Help support WeTheArmed.com by visiting our sponsors.

Author Topic: Sig P228 Grip Screw  (Read 1468 times)

MTK20

  • Senior Contributor
  • *****
  • Posts: 8044
  • Mind of a philosopher, mouth of a sailor.

  • Offline
Sig P228 Grip Screw
« on: September 25, 2019, 03:57:27 pm »
Well, I was out and about with my Sig P228 and when I got home one of the grip screws were missing  :banghead .

I don't need a full set of screws, but I wanted to make sure I get the right thing.

https://www.amazon.com/Hogue-P226-P228-Screws-Black/dp/B0010X8P1M

Would these work?  :shrug
Texas
Do we forget that cops were primarily still using 6 Shot Revolvers well through the mid 80's? It wasn't until after 1986 that most departments then relented and went to autos.
Capacity wasn't really an issue then... and honestly really it's not even an issue now.
Ray Chapman, used to say that the 125-grain Magnum load’s almost magical stopping power was the only reason to load .357 instead of .38 Special +P ammunition into a fighting revolver chambered for the Magnum round. I agree. - Massad Ayoob

Paradoxically it is those who strive for self-reliance, who remain vigilant and ready to help others.

WeTheArmed.com

  • Advertisement
  • ***

    coelacanth

    • Senior Contributor
    • *****
    • Posts: 10040
    • eccentric orbit

    • Offline
    Re: Sig P228 Grip Screw
    « Reply #1 on: September 26, 2019, 01:32:39 pm »
    Dunno' - never had the occasion to replace such a thing before.  Maybe the SIG web site has them for sale or at least a picture of the item so you can see if they look like the ones on Amazon.
    Arizona" A republic, if you can keep it."

                                                   Benjamin Franklin

    cpaspr

    • Senior Contributor
    • *****
    • Posts: 2242

    • Offline
    Re: Sig P228 Grip Screw
    « Reply #2 on: September 27, 2019, 03:14:04 pm »
    I googled "P228 grip screws" and after getting past the Amazon hits, found this:

    https://www.topgunsupply.com/gun-parts/sig-sauer-parts/shop-sig-sauer-gun-parts-by-category/grip-screws.html

    It's per each, in case you really only want one.

    Also, once you get what you need, use blue Lock-tite (and yes, I found out I needed it the same way you're finding out).
    Oregon

    Help support WeTheArmed.com by visiting our sponsors.