Help support WeTheArmed.com by visiting our sponsors.

Author Topic: Norma brass questions  (Read 929 times)

Fenris

  • The Big Bad Wolf
  • Member
  • **
  • Posts: 103
  • "GRRRRRRRRR."

  • Offline
Norma brass questions
« on: April 01, 2017, 09:34:51 PM »
I got my 223 AI rifle from the gunsmith. I bought a couple hundred rounds of the tac-223 fmj ammo. I figured it was going to be good norma brass. It fire-formed well and resized fine. Then, after loading it as Ackley ammo and shooting again, it sticks in the sizing die hard and the rim pops off with no excess pressure trying to extract from the die. Is norma brass really soft? Or is this stuff cheaper than the regular, unfired reloading brass? I'm kinda at a loss.

Sent from my SAMSUNG-SM-G890A using Tapatalk

"Evil man, Dead man."  the Saints

WeTheArmed.com

  • Advertisement
  • ***

    coelacanth

    • Senior Contributor
    • *****
    • Posts: 7138
    • eccentric orbit

    • Offline
    Re: Norma brass questions
    « Reply #1 on: April 04, 2017, 03:38:46 AM »
    Norma is usually good quality brass.  You might have gotten a bad batch but I wouldn't bet on it.  Did you get any signs of excess pressure when you fired your loaded AI ammo?  Carbide dies?  Case lube?    :hmm
    Arizona"A dying culture invariably exhibits personal rudeness.  Bad manners.  Lack of consideration for others in minor matters.  A loss of politeness, of gentle manners, is more significant than is a riot."
                          Robert A. Heinlein ,   Friday

    Help support WeTheArmed.com by visiting our sponsors.