Help support WeTheArmed.com by visiting our sponsors.

Author Topic: Looking for help  (Read 754 times)

snyd

  • Lurker
  • Posts: 1

  • Offline
Looking for help
« on: June 02, 2017, 08:11:36 PM »
Hi, my name is John Snyder and I am from Pa. My wife des odd jobs that require a industrial sewing machine. She has been asked to remake an old holster 1920 - 1930. She was going to use the old hardware but one of the posts was a rivet base and it broke. It was a post that the leather flap was pushed over so the post went through the leather flap. Does anyone know where a new one could be purchased. Thanks for ay help.
Pennsylvania

WeTheArmed.com

  • Advertisement
  • ***

    MTK20

    • Senior Contributor
    • *****
    • Posts: 5537
    • Mind of a philosopher, mouth of a sailor.

    • Offline
    Re: Looking for help
    « Reply #1 on: June 02, 2017, 08:15:21 PM »
    Hi, my name is John Snyder and I am from Pa. My wife des odd jobs that require a industrial sewing machine. She has been asked to remake an old holster 1920 - 1930. She was going to use the old hardware but one of the posts was a rivet base and it broke. It was a post that the leather flap was pushed over so the post went through the leather flap. Does anyone know where a new one could be purchased. Thanks for ay help.

    Luke Adams sources leather for his holster business. Perhaps he could help you.

    http://wethearmed.com/profile/?u=1989
    Texas
    Do we forget that cops were primarily still using 6 Shot Revolvers well through the mid 80's? It wasn't until after 1986 that most departments then relented and went to autos.
    Capacity wasn't really an issue then... and honestly really it's not even an issue now.
    Ray Chapman, used to say that the 125-grain Magnum load’s almost magical stopping power was the only reason to load .357 instead of .38 Special +P ammunition into a fighting revolver chambered for the Magnum round. I agree. - Massad Ayoob

    Paradoxically it is those who strive for self-reliance, who remain vigilant and ready to help others.

    LowKey

    • Member
    • **
    • Posts: 194

    • Offline
    Re: Looking for help
    « Reply #2 on: June 02, 2017, 11:41:00 PM »
    Are these the type of fasteners you're talking about?



    They're called, "lift the dot fasteners", should show up if you run a search for them.

    Help support WeTheArmed.com by visiting our sponsors.